PE Endorsement for Warehouse Racking and Storage Platforms in Singapore
Updated: Nov 12
Whether warehouse racking or a storage platform needs a Professional Engineer (PE) submission depends on what is being installed. A single level storage platform in an industrial building that stays within the limits in the Building Control Regulations 2003, including a height of not more than 4 metres and an area of not more than 50 square metres, is insignificant building works and needs no plan approval or permit from the Building and Construction Authority (BCA). Anything larger, multi-level, used as office or work space, or accessible to the public is building works that need approval. The structure must still be designed for its load, and Singapore Civil Defence Force (SCDF) fire safety requirements apply separately.
Racking or platform: why the difference matters
The Urban Redevelopment Authority (URA) draws the line clearly for planning purposes. A racking system is excluded from gross floor area (GFA) when it is:
Standalone, modular and not an integral part of the building.
Used for storage in an industrial development, related to the main industrial use.
Accessed by people only for the storage and retrieval of goods.
URA then reminds applicants to seek clearance from BCA for structural safety and from SCDF for fire safety. A system that goes beyond those conditions, for example a platform used as a work area or office, is no longer simple racking. It is closer to a mezzanine, and the approvals in our guide to mezzanine floor approval apply.
When does BCA approval apply?
BCA requires a permit for all building works except the insignificant building works listed in the First Schedule of the Building Control Regulations 2003. Three entries in the current Schedule matter for storage:
Item (j): any pipe rack or support not exceeding 2,000 millimetres in height.
Item (m): any plinth or other base not exceeding 2.5 metres in height and not supported by piled foundation, used solely to support items such as mechanical plant, tanks, equipment or machinery not exceeding 2.5 metres in height, where the space on or below it is not accessible except for maintenance.
Items (za) and (zb): a single level storage platform, and the staircase, ladder or similar device used solely for access to it.
Which storage platforms need no BCA approval?
Under item (za), a single level platform, including the space below it, is insignificant building works only if it meets all of these conditions:
It is used solely for the storage of goods.
It is located in an industrial building or a part of an industrial building.
It is not accessible to the public.
It does not exceed 4 metres in height and does not exceed 50 square metres in area.
No span of a beam or slab that is part of the platform exceeds 6 metres.
No span of a cantilever that is part of the platform exceeds 3 metres.
A platform within all of these limits needs no BCA plan approval or permit. A platform that is higher or larger, has more than one level, is used as an office or work area, or is accessible to the public is building works. In that case only a Qualified Person who is a PE in the civil or structural discipline can apply for structural plan approval, and the permit to carry out structural works is applied for jointly by the developer, the Qualified Person and the builder.
The exemption removes the BCA submission and nothing else. The platform still has to be designed to carry its load, and SCDF fire safety requirements, URA's GFA treatment and the landlord's consent are separate and may still apply. Our article on insignificant building works goes through the full list, and PE endorsement vs QP submission explains the two routes.
What does SCDF require for storage and racking?
The Fire Code 2023 controls how much can be stored and how high. In a factory (Purpose Group VI), clause 9.6.1c limits storage:
In a factory unit without sprinklers, storage areas including transient storage are limited to 100 square metres in aggregate.
With an automatic sprinkler system, that limit can be increased to 700 square metres.
Beyond the limit, either the whole unit must comply with the general warehouse requirements, or the storage must be compartmented from the factory.
SCDF treats the use of factory space as storage as a change of use, which is covered in factory change of use.
In a warehouse (Purpose Group VIII), clause 9.8 adds:
Compartment size and storage height limits in Table 9.8A, which depend on the storey and on whether the warehouse is sprinkler-protected. Sprinklers are required if the compartment exceeds the table limit.
Storage height signage. Maximum storage height must be shown on the building plans and marked on the walls, with a red line and the words "No Storage Above This Line", at intervals of not more than 15 metres.
High-rack storage with access platforms. Sprinkler coverage must extend to the areas shielded by the platforms, and the platform supports need the same fire resistance as the warehouse structure.
Changes like these go through an SCDF fire safety submission.
What does MOM expect of the racks themselves?
The Ministry of Manpower (MOM) issued a circular on the safe use of storage racks in May 2015 after several deaths in warehouses from rack collapses over the preceding two years. It reported a common finding: the racks were not properly designed for the intended storage loads. Its guidance includes:
Racks must be structurally stable and designed for the intended use.
The safe working load should be prominently displayed. Where racks are stacked, the lower racks must be designed for the weight of the upper racks and their goods.
The design should be re-assessed before any change of use, including a change in the goods stored.
Racks, accessories and pallets should be inspected regularly, and defective parts repaired or replaced before use.
Where does a PE come in?
Platforms and mezzanines outside the exemption: structural design and BCA submission by a PE acting as Qualified Person.
Platforms within the exemption: structural design for the intended load, and a check that every limit is met.
The floor underneath: racking concentrates load on baseplates, so the existing slab must be checked for the new loading. See machine foundations and floor loading.
Existing installations: a platform put up without approval can be assessed for regularisation of unauthorised works.
Which authority and regulation governs what?
BCA: structural safety under the Building Control Act and Building Control Regulations.
SCDF: fire safety under the Fire Safety Act and the Fire Code 2023.
URA: whether the installation counts as GFA.
MOM: workplace safety of racks in use, under the Workplace Safety and Health Act.
Landlord: tenants should check lease conditions before installing. For JTC premises, see JTC factory renovation consent and submissions.
What goes wrong
A vendor installs a "racking platform" as if it were furniture. In January 2025, a mezzanine floor in a Toa Payoh warehouse collapsed, trapping three people. Authorities later said it had been installed without SCDF or BCA approval. Unauthorised building works carry a fine of up to $200,000, up to two years' jail, or both. More cases are discussed in lessons from recent enforcement.
A platform is assumed to be exempt when it exceeds 50 square metres, has a second level or is used as a work area.
Racks are stacked or re-used for heavier goods without re-assessment, the pattern MOM identified in fatal collapses.
FAQ
Does a storage platform need BCA approval?
Not if it is a single level storage platform in an industrial building within all the First Schedule limits, including 4 metres in height and 50 square metres in area. Otherwise it is building works that need plan approval and a permit.
How much storage is allowed in a factory unit?
Under the Fire Code 2023, 100 square metres in aggregate without sprinklers, or up to 700 square metres with an automatic sprinkler system, unless the unit meets warehouse requirements or the storage is compartmented.
Sources
CVC Engineers advocates education and public awareness, and has a dedicated team to help resolve this properly. To discuss a racking or platform installation, WhatsApp +65 9342 7551. Last reviewed: November 2026.


Comments